[. . . ] € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. WARNING You Need to: ■ Slowly open dishwasher door while someone grasps the rear of the dishwasher. [. . . ] Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). If the drain hose was cut, use a 1¹⁄₂" to 2" (3. IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50. Helpful Tip: To reduce vibration of the hose, keep the hose away from the floor. If the drain hose was cut, use a 1¹⁄₂" to 2" (3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. 10 Option D, No waste disposer – with air gap Prepare Dishwasher WARNING Tip Over Hazard Do not use dishwasher until completely installed. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. If the drain hose was cut, use a 1¹⁄₂" to 2" (3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. Remove and discard the foam blocks located above the front legs on each side of the dishwasher. Use ¹⁄₄" hex-head socket, nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. Put wheels in the required position determined from “Dishwasher Height Adjustment Chart. € 14 Option A, Countertop Attachment Built-up floors: If the kitchen floor is higher than the cabinet opening's floor - for example, the kitchen floor tile does not extend into the cabinet opening - add shims as needed in the area shown to bring the dishwasher up to 34" (86. NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use. Remove the brackets from the package and insert into the open slots on the left and right-hand top of the dishwasher collar as shown. Check that water line is on the left side of opening and drain hose is near the center of the cabinet opening. With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted. 16 To adjust the door spring tension, unhook the spring from the rear leg of dishwasher. Using a ⁵⁄₁₆" nut driver or hex socket, remove the screw from the tensioner. The screw can be put into one of three holes (1, 2, 3) in the front leg of dishwasher. [. . . ] 21 Secure dishwasher to countertop Locate brackets on top of dishwasher and secure dishwasher to countertop with two , #10 x ¹⁄₂" Phillips-head screws (included). The dishwasher must be secured to keep it from shifting when door is opened. Side mount dishwasher to cabinet NOTE: If side mounting dishwasher to cabinet, you must drill pilot holes in cabinet to avoid splitting the wood. locate brackets on side of dishwasher and secure dishwasher to cabinet with two , #10 x ¹⁄₂" Phillips-head screws (included). [. . . ]